Communication is an essential pillar for patient safety, especially when there is a transfer of responsibility in the provision of health care. To systematize the scientific evidence on the subject of effective communication via the use of ISBAR. A Systematic Literature Review with an exploratory character and a qualitative approach was used. The search for the studies carried out having a search made in the CINAHL Plus databases and MEDLINE, both with Full Text........

Keywords: Handover, SBAR, communication, Nursing

This paper substantiates a methodological model for university development in an artificial-intelligence-saturated environment. The research problem lies in the widening gap between the rapid diffusion of generative AI in teaching and learning and the slower maturation of university regulations, assessment models, and staff capabilities. The study combines systems, institutional, ecosystem, and socio-technical approaches. It is based on a comparative review of scholarly publications from 2022 to 2025 and on the secondary interpretation of Russian and international empirical materials, including HSE ISSEK and VTsIOM analytical reports. The paper shows that the decisive issue for higher education.......

Keywords: artificial intelligence, higher education, educational ecosystem, digital campus, organizational digital consciousness, university management.

This paper analyses the influence of rolling process parameters on the resulting surface micro geometry of galvanized sheets. The study focuses on the role of chrome plated work rolls, the control of thickness and mechanical properties in the weld area, and the identification of the most common defects occurring during skin pass rolling. In the experiment surface roughness measurements (Ra, RPC) were performed on samples taken from a galvanized strip, complemented by visual flatness evaluation and imprint inspection. The results confirm that the stability of technological parameters is crucial for eliminating defects and ensuring the required surface quality.

Keywords: galvanized sheets, surface micro geometry, work rolls, flatness.

The article presents information on unconventional production methods of forming tools with the use of laser techniques in combination with poplar plywood. The bending die was produced using 4 mm thick sheets of plywood cut by laser. The bending die was experimentally tested, as well as tested in a virtual environment using numerical simulation in the Solidworks 2022 program. The bender withstood 12 bending operations of thin steel sheets without failure, the largest load force was 1,560 N, and it could be used further.

Keywords: Tool material, bending die, plywood, simulation